WaveWare Apollo T-2000 Información técnica descargar pdf (Pagina 39)

Certification Manual

- 39 -

Concord Touchpad has six wires that are soldered onto the back of the

circuit board. However, only four of these are used, the red, black, green

and white. The two yellow wires can be ignored. As with the control panel,

the Red and Black wires are positive and negative respectively, while the

green wire is Bus A and the white wire is Bus B.

Once the touch pad is powered up, it will automatically show,

“Scanning for Bus Devices”. This is a function of the control panel by which

it automatically scans the entire bus line for new or changed modules. The

touchpad does not have non-volatile memory, so the time and date must be

set every time it looses power. (Refer to the Concord Programming

Section)

With regard to the buttons on the front of the touchpad, there are

numeric buttons labeled 0-9 including star and pound. To the left of these

there are four buttons labeled A, B, C and D. Whenever the user desires to

view the system status, they may do so by pushing the star button. This will

show them any calls that are open, any system errors or tests that are

occurring. This is a very important feature. Anytime system programming

must be changed, this must be done by entering the programming mode.

This procedure will be described in the Concord Programming Section.

Automation Module

The Super Bus 2000 Automation

Module is the link between the Concord Panel

and the Server Computer. The Automation

Module passes on all the information

regarding system status through a serial port

which can be directly connected to the Server

Computer. This information is encoded in a communications protocol that

GE developed known as the Advent Protocols.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 113 114

Sin comentarios

WaveWare Apollo T-2000 Información técnica Pagina 39