Waveware TMR1P Manual de usuario descargar pdf (Pagina 3)

DAVISCOMMS (S) PTE LTD

1 TMR1P Product Features

1.1 Product Description

The TMR1P is able to receive alphanumeric messages and send via the RS232 serial output to

any industrial standard display device. The RS232 port speed of 1200/2400/4800/9600/19200

baud rate with even/odd/none parity option can be set through the TPS. TMR1P supports both

numeric and alphanumeric vector. However, there are some constraints in using numeric vector to

send the control codes for both control and display data, which will be specified in the relevant

sections.

1.2 Receiver Frequency

The TMR1P’s receive frequency is normally set during the production of the units in accordance

to customers’ specifications. The receive frequency can be changed by using the TMR

Programming Software (TPS) by programming the frequency synthesizer.

1.3 Multiple Addressing

The TMR1P can support up to 7 POCSAG capcode addresses.

1.4 LED Indication

The following table describes the different indications of the LED for different conditions:

S/No LED Indication Status Condition

01 Continuously on Reset is successful After Power on

02 Blinking every half a second EEPROM failure After Power on

03 Blinking every 2 seconds until

synchronization is restored

Lost synchronization or Out

Of Range (OOR)

Power on and in

Stand-by mode

04 Blinking every 0.3 second for

up to 3 seconds

Receiving a new message Power on and in

Stand-by mode

1.5 Output Control Codes

The TMR1P is able to control different industrial applications such as motor, relay,

lighting and electronic-lock by sending the right control codes through its 8 output ports

(1/0/k/s/r).

When a port control code sent is “1”, the corresponding output port is set to high state or source

state.

3 500088R03

DAVISCOMMS (S) PTE LTD

Blk70 Ubi Crescent #01-07 Singapore 408570. Tel: (65) 65471127 Fax: (65) 65471129

1 2 3 4 5 6 7 8 ... 25 26

Sin comentarios

Waveware TMR1P Manual de usuario Pagina 3