WaveWare SPS5 V9 Especificaciones descargar pdf (Pagina 18)

On the Main Screen of Encoder Setup Program, Click on “Group Paging” to Open the Pager Database.

See Fig. 8

Fig. 8 (Group Paging)…Configuration

Pager Groups Screen: Enter The Group ID and list the pager ID’s you want in that group. The ID’s must be in the Pager

Families, programmed previously. Note: In most cases you would use a “Common” Pager Cap Code in the Pager

themselves instead of using Pager Groups. Using a Common Cap code will page all pagers at the same time; whereas

using a group will page each pager one at a time, which is slow.

Pager Groups would be used primarily when “Timer Active” Mode is needed. When finished, Click “OK” See Fig. 9

Fig. 9 (Pager Groups Setup) If Group 1 is RED, click on the Box to Activate that Group, it will turn Green.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 58 59

Sin comentarios

WaveWare SPS5 V9 Especificaciones Pagina 18