Waveware Adaptive Remote Manual de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 102
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
BetaBrite Programming Manual (pn 9703-6020) November 4, 2003
14 Installation
Using a computer to operate your sign
Messages can also be programmed into the sign using a computer. To
do this, you’ll need special connectors and computer software, either
AlphaNET or BetaBrite Messaging Software. Follow the instructions that
come with the software CD to program messages.
Item Part # Description
A Ferrite (ferrite end towards sign), supplied with data cable
B
1088-8625 25-foot 6-conductor RS232 data cable
1088-8627 50-foot 6-conductor RS232 data cable
C
4370-0001C 25 pin sub-D/to 6 pos. RJ11 adapter
1088-9108 9 pin sub-D/to 6 pos. RJ11 adapter
D Power supply
E
1102-9102 BetaBrite Messaging Software
1092-7827 AlphaNET software
PC running
BetaBrite
Messaging
Software or
AlphaNET
software
NOTE: A BetaBrite sign can only be connected to one computer. It can not be
networked to more than one computer or to another BetaBrite sign.
NOTE: Use only the power supply (Item D) that came with the sign. Set it flat, so that
it’s not dangling by the cord. Do not fasten it to anything.
NOTE: Connecting a surge protector between the electrical outlet and the sign is highly
recommended. Message data can be lost or the sign could be damaged by
power fluctuations.
NOTE: Electrostatic discharge, or carpet shocks, can also cause data loss and damage
to the sign. Avoid touching the sign after it’s been installed, especially in cold,
dry winter air.
NOTE: Do NOT connect a telephone to the sign’s RS232 jack and do NOT try to
substitute ordinary telephone wire for any parts listed below.
A
B
C
To the sign’s
RS232 jack
(on the side)
To one of
the PC’s
COM
(RS232)
ports.
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 101 102

Comentarios a estos manuales

Sin comentarios